Description:
It is an aliphatic polyurethane-based, one
component, highly elastic, UV resistant,
seamless, and excellent crack bridging
waterproofing material.
Areas of Use:
It is used on roofs, balconies and terraces,
light roofs made of metal and fiber
materials, concrete, plaster, screed, repair
mortar, plastered brick, gas concrete
and briquette surfaces, in the protection
and waterproofing of bridges and similar
reinforced concrete structures.
Product Advantages:
• It is easy to apply.
• It provides seamless and continuous
waterproofing on the applied surface.
• It is resistant to UV rays.
• It provides permeability for water vapor.
• The film has air permeability and prevents
moisture from accumulating in the lower
layer.
• It can be walk on.
• It has excellent mechanical and chemical
properties, provides high tensile strength,
and tear and abrasion resistance.
• It is resistant to outdoor weather
conditions
• It can be used in crack bridging due to its
highly elastic structure.
Application Information:
Application Temperature: (+5°C) – (+35°C)
Crustation Time: 6-12 hours
Time Enabled to Walk On: 12-36 hours
Ultimate Cure Time: 7 Days
Average Consumption: 0,600-0,800 kg/m²
(for one layer)
*These values are valid for 23°C and 50%
relative humidity. Time periods may vary
depending on ambient conditions.
Surface Preparation:
-The surface must be clean and dry, and
free from oil, dirt, grease, coatings and other
types of dirt that will prevent adhesion.
– Large fractures and faults must be
repaired beforehand.
– Corners and joints in the application area
must be chamfered beforehand.
-The cement crust and glossy screed sand
on the concrete surface must be cleaned
and the surface must be roughened and
wiped with tools such as notching machine,
wiping machine with diamond drum,
powered grinding machine.
-The entire surface must be freed from dust
with an industrial vacuum cleaner.
-The surface must be prepared by priming
with BOYTİM 955 Waterproof UV+.
Preparation of the Mixture:
Before applying BOYTİM 955 Waterproof
UV+, it must be mixed for 3 minutes in order
to obtain a homogeneous consistency.
Application:
BOYTİM 955 Waterproof UV+ must be
poured on the primed surface and spread
with a brush or roller until the entire surface
is covered.
It can be applied using an airless spray on
large surfaces.
– Problematic areas such as wide surfaces,
floor-wall joints, parapet corners, chimney
flashings should be strengthened. For this, a
50 – 60 g/m² synthetic felt must be used.
BOYTİM 955 Waterproof UV+ must be
applied on the surface with a brush or roller,
and must be placed on the surface by
compressing where polyester felt is applied.
BOYTİM 955 Waterproof UV+ must be
applied until the felt is saturated.
– The second coat must be applied 12
hours after the first coat is applied (within
maximum 36 hours).
– It contains solvent, and it is flammable.
Do not approach with an open flame and
do not smoke during application.
– Cracks, capillary cracks and joints should